Metal identification of Professional Search Finder Gold Detector Treasure Hunter This method can identify the non-ferrous metal (gold, silver, copper) and black metal (magnetic metal such as steel, iron, etc.). Also can selected target metal to be detecting, but in this mode the instrument no Ground balance function, can't not cancel the "mineralization reaction", which required strictly keep the distance with the ground probe unchanged, along the ground slowly moving in parallel.
Postupak operacije je sljedeći:
1) Mode switch move to " Recognition" position.
2) Turn on the power switch, press the reset button and release, turn power switch clockwise until the " Critical sound" heard.
3) Adjust according to the specific circumstances of "Work Adjustment" knob to excluded those who do not need to target, such as many nails all around the detecting area, everywhere is the signal sent by the nails detected, correct detection work in not convenient, in this case you could put a nail on the
ground, move the probe above the nail, if the instrument sound great, just press the reset button
and turn the " work adjustment" knob anti-clockwise (turn left) and then try again, if the sound is reduced, move the probe above the nail again, press the reset button and release, and turn the "work adjustment" knob anti-clockwise (turn left) little bit, then move the probe to the nail, if still have sound, repeat the above procedure again until move without sound. After this adjustment, the small nails on the ground can't make the instrument sound, you can start the detection job to detect the black metal size is greater than the nail or non-ferrous metal those will let instrument issue by
glasan zvuk.
4) Turn the "Work Adjustment" knob to scale 2 or below, only a larger size of non-ferrous metal to make the sound increases, a larger size of black metal sound reduction. If "Work Adjustment" knob turn to scale 7 or above, a larger size of non-ferrous metal to make the sound reduced, a larger size of black metal sound increased. If the detected target is a sheet of black metal, it will be a particular phenomenon: if the probe move to the edge of it, it should be the same as the reaction of ferrous metal, but when the probe is at the sheet center, it was just like the non-ferrous metal.
